Four Wave Mixing Signals Generation at 25 dBm High Power EDFA

Authors

  • Junaidi Jamaludin Optical Fibre Laser Technology Group, Physics and Chemistry Department, Faculty of Applied Sciences and Technology, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.
  • Noor Azura Awang Optical Fibre Laser Technology Group, Physics and Chemistry Department, Faculty of Applied Sciences and Technology, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.
  • Zahariah Zakaria Optical Fibre Laser Technology Group, Physics and Chemistry Department, Faculty of Applied Sciences and Technology, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.

Keywords:

Four Wave Mixing, Two mode fiber, EDFA, Bio-sensor

Abstract

A four wave mixing (FWM) signal generation based on few mode fiber laser (FMF) has been demonstrated using a high power Erbium Doped Fiber Amplifier (EDFA) in a linear cavity. The proposed cavity can generate the highest peaks of four wave mixing signals at wavelength of 1550 nm and 1551 nm at a given of 25 dBm input power from EDFA with output peaks power of -2.55 dBm and -6.43 dBm were generated respectively. The lowest Optical Signal to Noise Ratio (OSNR) for the peak probe was recorded at 50 dB that negates minor fluctuations in cavity. The idlers were obtained at 9.1 dB and 4.4 dB OSNR at 1549.1 nm and 1552.4 nm respectively. It is expected that this laser cavity will be an alternative platform to develop bio-sensor by utilizing nonlinear properties of photon in order to meet the increasing demand in medical study.

Downloads

Download data is not yet available.

Downloads

Published

28-12-2017

How to Cite

Jamaludin, J., Awang, N. A., & Zakaria, Z. (2017). Four Wave Mixing Signals Generation at 25 dBm High Power EDFA. Journal of Science and Technology, 9(3). https://penerbit.uthm.edu.my/ojs/index.php/JST/article/view/2152

Most read articles by the same author(s)